IBM SAN Volume Controller 2145-CF8, Hardware Installation Manual

Page: 62 / 101

display when you press the buttons. After you finish testing the buttons, press
and hold the select button for five seconds to exit the test.
4.
If the
Charging
or
Recovering
message is displayed on the front-panel display,
press the select button to switch to the menu. The menu continues to be
displayed while you press the buttons on the front panel. If you do not press
any buttons within 60 seconds, the menu changes to display the charging
progress. You can switch the front-panel display to the menu at any time by
pressing the select button again.
5. Press and release the up button or down button until the Node: option is
displayed on the first line of the front-panel display.
6. Verify that the node number that is displayed on the second line of the
front-panel display is the same as the node number that is printed on the
front panel of the node. Figure 37 shows how the node number is displayed
on the front panel. If the node number is not the same, contact the IBM
Support Center.
7. Press and release the up button or down button until the Ethernet option is
shown on the front-panel display. The second line of the front-panel display in
Figure 38 shows the message
No Cluster .
8. Press and release the right button to view the values given on the second line
of the front panel display for the
Ethernet Port-1
option, the
Speed-1
option,
the
MAC Address-1
option, the
Ethernet Port-2
option, the
Speed-2
option,
and the
MAC Address-2
option.
Make sure that an Ethernet cable is attached to Ethernet port 1, which is the
port to the left when viewed from the rear. Ethernet port 2 is optional.
Figure 36. Front-panel display when push buttons are pressed
N o d e :
x x x x x x
Figure 37. Node number
E t h e r n e t :
N o C l u s t e r
Figure 38. Ethernet: No Cluster
36
IBM System Storage SAN Volume Controller: Model 2145-CF8 Hardware Installation Guide