IBM S822LC, Servicing

Page: 97 / 146

Note: If you plan to remove dust or debris from the heat sink, this operation must be performed
in another room that is greater than 7.6 m (24.9 ft) away from the work area.
4. Remove dust and debris from the system processor module area.
a. If dust or debris is present, use the supplied air pump (part number 45D2645) to clean the system
processor module area. Blow small bursts of air from the center toward the sides of the system
processor module as shown in Figure 83 on page 82.
Figure 82. Removing the heat sink
Removing and replacing parts
81