IBM S822LC, Servicing

Page: 54 / 146

b. Pull out the memory riser from the slot by holding onto the latches.
c.
Place the memory riser on an ESD mat.
4. If applicable, move the memory DIMM from the removed riser onto the replacement memory riser.
For instructions, see “Removing and replacing memory DIMM from the 8335-GCA or 8335-GTA” on
page 31.
Replacing memory risers in the 8335-GCA or 8335-GTA
Learn how to replace a memory riser in the 8335-GCA or 8335-GTA system.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. To replace the memory riser, complete the following steps:
a. Ensure the release latches are open to about a 60 degree angle, as shown in Figure 39 on page 39.
b. Align the memory riser with the connector.
c.
Press the memory riser firmly into the connector.
d. Press the release latches into the closed position. See (A) in Figure 39 on page 39.
Figure 38. Removing a memory riser from the system
38
Servicing the IBM Power System S822LC (8335-GCA or 8335-GTA)