IBM RS/6000 44P 170, Installation Manual

Page: 56 / 86

5. Align the screw holes on the disk drive with the screw holes on the disk drive
cage.
6. Install the four previously removed shoulder screws. Ensure that the blue
grommets are in the correct position.
Note: The screws that secure the disk drive to the disk drive cage are special
shoulder screws. These screws and the blue grommets must be used when
installing a disk drive. Failure to use the blue grommets and special
shoulder screws can result in permanent damage to the disk drive. The
shoulder screws and blue grommets must also be used if you are installing
a one-inch high disk drive into the disk drive carrier.
7. Install the disk drive cage back into the system unit.
8. Install the previously removed disk drive cage retaining screw.
9. Reconnect all disk drive cables.
10. If you have additional options to install, refer to “Option List” on page 30 for the
appropriate page number, and skip to that section. Otherwise, continue with these
steps.
11. Replace the cover support bridge. See “Cover Support Bridge” on page 26.
12. Replace the left side cover. See “Replacing the Left Side Cover” on page 25.
13. Reconnect the system power cables.
14. Turn on the power.
15. Reboot, then configure the drive using SMIT. Then wait five minutes for the drive
to warm up. See “Drive Configuring” on page 41 for instructions on configuring the
drive.
44
44P Series Model 170 Installation Guide