IBM Power Systems 8001-22C, Manual

Page: 22 / 138

8. Plug the power cords into the power supplies.
9.
Attach all cables to the rear of the server.
Table 1. Input and output ports
Identifier Description
1 USB 2.0 used for keyboard and mouse.
Certain USB drives might be too wide to fit properly into
the USB ports on the rear of the system. Test the fit your
USB drive before proceeding.
2 Ethernet Intelligent Platform Management Interface
(IPMI)
3 Serial IPMI
4 Video Graphics Array (VGA) used for monitor. Only the
1024 x 768 at 60 Hz VGA setting is supported. Only up
to a 3-meter cable is supported. Text based capability is
only supported at this time.
10. Plug the system power cords and the power cords for any other attached devices into the alternating
current (AC) power source.
11. Continue with “Completing server setup.”
Completing server setup
Learn how to complete server setup.
Procedure
1. Connect your server to a VGA terminal and keyboard or a console. Only the 1024x768 at 60 Hz VGA
setting is supported. Only up to a 3 meter cable is supported.
2. Go to Getting fixes(http://www.ibm.com/support/knowledgecenter/POWER8/p8ei8/
p8ei8_fixes_kickoff.htm) and update the system firmware with the most recent level of firmware.
3. You can receive important technical information and updates for specific IBM Support tools and
resources by subscribing to receive updates. To subscribe to receive updates, complete the following
steps:
a. Go to the IBM Support Portal.
b. Log in by using your IBM ID and password and click Sign in.
c. Click Support notifications.
d. Click Browse for a product.
e. Select Power > Firmware, find your machine type and model and click Subscribe.
Figure 2. Rear ports
6
Power Systems: Installing the IBM Power System S822LC for Big Data (8001-22C)