IBM Power System 9009-22G, Manual

Page: 63 / 76

Checking the amount of remaining life in NVMe devices
Learn how to use operating system commands to find the amount of remaining life in an NVMe device.
The AIX
®
, IBM i, and Linux
®
operating systems have commands that you can use to determine the amount
of life that is remaining in an NVMe device.
For more information, see the following procedures:
• Running the AIX command to check the amount of remaining life in NVMe devices (www.ibm.com/
support/knowledgecenter/POWER9/p9hak/pxhak_nvme_remaining_life_aix.htm)
• Running the IBM i command to check the amount of remaining life in NVMe devices (www.ibm.com/
support/knowledgecenter/POWER9/p9hak/pxhak_nvme_remaining_life_ibmi.htm)
• Running the Linux command to check the amount of remaining life in NVMe devices (www.ibm.com/
support/knowledgecenter/POWER9/p9hak/pxhak_nvme_remaining_life_linux.htm)
Related information
“Removing an operational NVMe device from an IBM i logical partition” on page 49
Learn how to remove an operational NVMe device from an IBM i logical partition.
Removing an operational NVMe device from an IBM i logical partition
Learn how to remove an operational NVMe device from an IBM i logical partition.
The IBM i operating system provides commands that you can use to remove an operational NVMe device.
For details, see Removing an operational NVMe device from a partition in the IBM i Knowledge Center.
Note: To navigate to the page in the IBM i 7.4 Knowledge Center, select Systems management > Disk
management > Disk management checklist > Removing an operational NVMe device from a partition.
NVMe U.2 pass-thru card for the 9009-22G or 9223-22S 49