IBM PCI Data/Fax Modem, User Manual

Page: 12 / 46

Note: You will need to replace the existing PCI bracket with this bracket if
you are installing your modem in a computer that requires a
low-profile PCI bracket.
Installing the modem
This section contains instructions for installing the modem. For information on
uninstalling the modem, go to “Uninstalling the modem” on page 1-3.
Installing the modem in Windows 95, Windows 98 or
Windows Me
To install the modem in any of these operating systems, follow these steps. The
only difference is in step 10 for Windows Me, in which you type
e:\winMe\setup.exe
(where
e
is the letter of your CD-ROM drive).
1. Turn off the computer and all attached devices.
2.
Remove the computer cover.
3. Install the modem in an available PCI slot.
Note: You might need to attach the low-profile PCI bracket that is
included with this option.
4.
Replace the computer cover.
5. Turn on the computer and start Windows.
6. When the Add New Hardware Wizard window opens, click Cancel.
7. After Windows starts, click Start.
8.
Click
Run.
9. Insert the V.90 PCI Data/Fax Modem Device Drivers and User’s Guide CD into
the CD-ROM drive.
10. Type
e:\win9x\setup.exe
(where
e
is the letter of your CD-ROM drive).
11.
Click Next.
12. Click Finish.
Installing the modem in Windows NT 4.0
To install the modem in Windows NT 4.0, do the following:
1. Turn off the computer and all attached devices.
2.
Remove the computer cover.
3. Install the modem in an available PCI slot.
Note: You might need to attach the low-profile PCI bracket that is
included with this option.
4. Replace the computer cover.
5. Turn on the computer.
6. After Windows NT starts, click Start .
7.
Click Run .
8.
Insert the V.90 PCI Data/Fax Modem Device Drivers and User’s Guide CD into
the CD-ROM drive.
1-2
V.90 PCI Data/Fax Modem: User’s Guide