IBM System Storage N3700 A20 Setup
9
6. If no third-party device will be attached to the fibre channel ports (orange
ports), insert the fibre channel terminator or loopback terminator into the fibre
channel ports (orange ports) at the CPU modules (Node A and Node B)
(Figure 7).
Figure 7 Connecting Ethernet, console cables, and fibre channel terminator
7. If an EXN2000 disk shelf will not be attached, set the terminate switch on both
CPU modules (Node B and Node A) to ON (Figure 8).
Figure 8 No EXN2000 attached
If an EXN2000 will not be attached, proceed as follows (system is still off):
a. Plug in the power cord to the left and right power supplies.
b. Fasten the power cords with the hold-down clamps.
c. Plug the other ends of the power cords into the grounded ac power source.
d. Proceed with the initial setup in “Initial configuration” on page 13.