Figure 31. Removing a controller fan (1 of 2)
2. With your other hand, grasp the handle located on the top of the fan, and pull upwards to remove the
fan from its slot as shown in the figure below.
Figure 32. Removing a controller fan (2 of 2)
Installing a controller fan module
About this task
Refer to Figure 31 on page 61 and Figure 32 on page 61 when performing this procedure, but ignore the
directional arrow—since you will insert the module into the slot—rather than remove it.
Important: Handle the controller fan carefully, and avoid damaging connectors.
Procedure
1. Check for damage, especially to all module connectors.
2. Align the controller fan module for use in the fan slot that is accessible from the top panel.
3. Insert the controller fan module into the slot, and gently press down on the module until it seats firmly
in its connector.
4. Verify that the Controller Fan Status LED is off. Verify that the front panel LED states show no amber
module faults.
Chapter 7. Module removal and installation 61
Summary of Contents for Medium J11
Page 15: ...European Community and Morocco Notice Germany Notice Safety and environmental notices xv...
Page 103: ......
Page 104: ...IBM...
