Mainboard User’s Manual
Installing a Socket-462 Processor
Install a processor into the ZIF (Zero Insertion Force) Socket-462
on the mainboard.
1. Locate the Socket-462 and CPUFAN. Pull the locking lever
out slightly from the socket and raise it to the upright position.
2. On the processor, identify the Pin-1 corner by its beveled edge.
3. On the Socket-462, identify the Pin-1 corner. The Pin-1 corner
is at the top of the locking lever when it locked.
4. Match the Pin-1 corners and insert the processor into the
socket. No force is required and the processor should drop into
place freely.
5. Swing the locking lever down and hook it under the catch on
the side of the socket. This secures the CPU in the socket.
6. All processors should be installed with a combination heatsink/
cooling fan, connect the cable from the fan to the CPU fan
power connector CPUFAN.
Install Memory
The mainboard has two 168-pin/184-pin DIMM sockets for
SDRAM/DDR (Double Data Rate) SDRAM system memory
modules. You must install at least one memory module in order to
work out the mainboard,
either SDRAM or DDR SDRAM, but
you can not use them simultaneously.
10
CPUFAN
Socket-462
Pin-1 Corner
Summary of Contents for M841
Page 4: ...Mainboard User s Manual IV ...
Page 22: ...Mainboard User s Manual 18 ...
Page 31: ...3 BIOS Setup Utility 27 ...
