DANGER
To prevent a possible electrical shock from touching two surfaces with
different electrical grounds, use one hand, when possible, to connect or
disconnect signal cables. (RSFTD004)
__ 1.
Remove the back covers from your system unit and your 5075. Go to
“Appendix A. Removing the covers” on page 19 if you need instructions.
__ 2.
Connect an HSL cable to the HSL connector 0 on your 5075. Go to
“Appendix B. Connector Locations” on page 23 for connector locations.
__ 3.
If you are installing a redundant link, connect an HSL cable to HSL
connector 1 on your 5075.
__ 4.
Connect an SPCN cable to connector J15 on your 5075.
__ 5.
Install the power cable to your 5075.
Do not
plug it into the electrical
outlet.
__ 6.
Connect the HSL cable from connector 0 on your expansion unit to
connector A0 on your system unit.
__ 7.
If you are installing a redundant link, install the cable from connector 1 on
your expansion unit to connector A1 on your system unit.
__ 8.
Connect the SPCN cable from connector J15 on your expansion unit to
connector J15 on your system unit.
__ 9.
Install the back cover to your system unit and expansion unit.
__ 10.
Go to “Chapter 4. Completing your installation” on page 15.
8
Setting Up Your 5075 Expansion Unit V4R5
Summary of Contents for iSeries 5075
