IBM INFOPRINT COLOR 1454, Help Manual

Page: 12 / 40

Printing guide
Page 1 of 2
Printing guide
Get the most out of your printer by properly loading the
trays and setting the types and sizes. Never mix media
types within a tray.
Note: Paper Size cannot be adjusted when
auto size sensing is enabled. Auto size
sensing is enabled by default for printer
trays, but is not available for the
multipurpose feeder.
Load paper or other print media
To help prevent jams:
• Flex all stacks of print media back and forth to
loosen them, and then fan them before loading.
Do not fold or crease the print media. Straighten
the edges of the stack on a level surface.
• Do not exceed the maximum stack height.
Overfilling may cause jams.
• Never remove paper trays while a print job is
printing. It could damage the tray or the printer.
Loading 500-sheet trays
1 Remove the tray.
2 Squeeze the front guide lever and slide the guide
to the front of the tray.
3 Squeeze the side guide lever and slide the guide
to the correct position for the size paper you are
loading.
4 Flex the sheets back and forth to loosen them,
and then fan them.
5 Place the paper against the back left corner of
the tray, print side down.
6 Squeeze the front guide lever and slide the guide
until it firmly touches the stack of paper.
7 Reinstall the tray.
8 If you are loading a different type of media than
was previously loaded in the tray, change the
Paper Type setting for that tray on the operator
panel. See “Set Paper Type and Paper Size” on
page 2.
Loading the multipurpose feeder
1 Open the multipurpose feeder.
2 Squeeze the paper
guide lever and
slide the guide all
the way toward the
front of the printer.
3 Flex the sheets
back and forth to
loosen them, and
then fan them.
4 Arrange the stack
of print media
correctly for the
size, type, and print
method you are using.
5 Place the print media, print side up, along the left
side of the multipurpose feeder, and then push it
in as far as it will easily go. Do not force the
media.
6 Squeeze the paper guide lever and slide the
guide until it lightly touches the side of the stack.