IBM HC10 - BladeCenter - 7996, Installation And User Manual

Page: 30 / 74

Removing the blade workstation bezel assembly
To install certain optional devices, you might choose to first remove the blade
workstation bezel assembly. The following illustration shows how to remove the
bezel assembly.
Control-panel connector
Control-panel cable
Bezel-assembly
release
Bezel-assembly
release
Bezel
To remove the blade workstation bezel assembly, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 15.
2. Open the blade workstation cover (see “Opening the blade workstation cover”
on page 17 for instructions).
3. Disconnect the control-panel cable from the control-panel connector.
4. Press the bezel-assembly release and pull the bezel assembly away from the
blade workstation approximately 1.2 cm (0.5 inch).
5. Pull the bezel assembly completely away from the blade workstation.
6. Store the bezel assembly in a safe place.
18
BladeCenter HC10 Type 7996: Installation and User’s Guide