IBM FC 2704, Installation Instructions Manual

Page: 21 / 56

10.2.3 Installing the cable management arm
Included in the cable management box are cable ties or hook-and-loop fasteners, and a large cable tie or
hook-and-loop strap. Use these items to neatly bind the cables in the cable management arm assembly. In
the table, the numbers in parenthesis indicate the quantity of each item, provided. See Figure 9 and
Table 2.
Table 2. Cable management box contents
▌1▐
Cable management arm mounting bracket (1)
▌4▐
Cable management arm assembly (1)
▌2▐
Cable management arm stop bracket (1)
▌5▐
Cable ties or hook-and-loop fasteners (5)
▌3▐
Cable management support arm (1)
▌6▐
Large cable tie or hook-and-loop strap (1)
__ 1. See Figure 10 on page 16. To install the support arm:
__ a. Push the slide rails and tray all the way into the rack until they click into place.
__ b. At the rear of the rack, connect the short-tab end of the support arm, shiny slide up
▌1▐
, to
the left slide rail.
__ c. Swing the other end of the support arm
▌2▐
toward the rack to lock.
1
2
3
4
5
6
ts760966
Figure 9. Cable Management box contents
Installation (Sections 9 through 12)
15