IBM eServer xSeries 235 Type 8671, Option Installation Manual, Page: 78 / 102

The following illustration shows how to install the server top cover on a rack
configuration server.
Top cover
Cover release
latch
C
PU
VR
M
M
EM
O
RY
H
D D
PC
I B
U S
N
M I
SM
I
SE
RV
IC
E P
RO
C
ES
SO
R
BU
S
N O
N R
ED
U
N DA
N
T
PO
W
ER
S
U PP
LY
1
2
3 A
B
1
2
3
FA
N
TE
M PE
R
AT
U R
E
Flange
Flange
Complete the following steps to install the server top cover:
1. Before installing the cover, check that all cables, adapters, and other
components are installed and seated correctly and that you have not left loose
tools or parts inside the server.
2. Place the cover-release latch in the open (up) position.
3. Place the lip of the left side of the top cover over the top-left edge of the server
chassis.
4. Rotate the top cover to a horizontal position, inserting the tabs at the right side
of the top cover into the matching slots in the server chassis.
5. Slide the top cover forward until it locks in place.
6. If you disconnected any cables from the back of the server, reconnect the
cables; then, plug the power cords into properly grounded electrical outlets.
Note: If necessary, see Chapter 3, “Input/output ports”, on page 71 for
connector locations. The
Rack Installation Instructions provided on the
IBM xSeries Documentation CD also give additional rack installation and
cabling information. These instructions also come with the Tower-to-Rack
Conversion Kit.
Updating your server configuration
When you start your server for the first time after you add or remove an internal
option or an external SCSI device, you might see a message telling you that the
configuration has changed. The Configuration/Setup Utility program automatically
starts so that you can save the new configuration information. See the
User’s Guide
on the IBM xSeries Documentation CD for more information about the
Configuration/Setup Utility program.
Some options have device drivers that you need to install. See the documentation
that comes with your option for information about installing any required device
drivers.
Your server comes with one or two microprocessors installed on the system board.
If your server comes with two microprocessors, or if your server comes with one
66
IBM xSeries 235 Type 8671: Option Installation Guide