IBM eserver 7210, Setup And Operator Manual

Page: 27 / 38

Chapter 3. Using the 7210 DVD-RAM Drive
This chapter describes the operator controls and indicator lights on the 7210 Model
025 DVD-RAM Drive. It gives instructions for loading and unloading a DVD disc,
and provides information about cleaning the drive and the discs.
Figure 9 shows a front view of the 7210 Model 025 DVD-RAM Drive.
Operator Controls
The 7210 Model 025 DVD-RAM Drive has the following operator controls.
Power Switch
The power switch (
2
in Figure 9) is a push button switch that enables the power
to be turned on or off. When the 7210 DVD-RAM Drive is on, the power-on light
1
is on and is green.
Note: The symbol under the power-on light is an International Organization
for Standardization (ISO) symbol for a push button switch.
Load/Unload Button
The load/unload button
3
enables the DVD-RAM tray to be inserted or ejected.
To insert or eject the tray, press and hold the load/unload button for about one
second. The load/unload button operates only when the 7210 DVD-RAM Drive
power is on.
Manual Unload Hole
When a power failure or a DVD-RAM drive failure prevents the disc from ejecting,
the disc can be removed manually. First, unplug the device from the power source.
Insert a solid metal rod (such as a paper clip or bristol wrench) into the manual
unload hole
4
until resistance is met, then gently push to unlatch the DVD-RAM
disc tray (this will take several attempts to unlatch the tray.)
RBBTP513-0
Figure 9. Front View of the 7210 Model 025 DVD-RAM Drive
© Copyright IBM Corp. 2001
13