IBM storage products
Page 2
IBM Technology Group Support Center
version 3.1
Attaching the drive
1. Turn off the computer, unplug the power cord, and
open the cover.
2. Match pin 1 of the 40 pin cable to pin 1 of the drive
interface connector. Pin 1 is usually denoted by a
stripe along the edge of the cable.
3. Insert a power plug in either the 3 or 4 pin power
connector.
Configuring your computer
1. If your computer has a plug-in IDE card with a drive
installation procedure, follow the manufacturer’s in-
structions.
2. Plug in the power cord and power on your com -
puter. Your computer may detect a configuration
change and prompt you to proceed to the Setup
screen.
3. If your computer does not prompt you to recon-
figure, enter your computer’s Setup, typically by key
selection or keyboard combinations during power-on
or during a reboot. Refer to your computer’s docu-
mentation for the proper key sequence. If the com -
puter fails to boot up, power off, remove the new hard
drive and return your system to its original config-
uration. Reboot and enter your computer’s Setup.
Follow the directions in step 4, then reattach the new
hard drive.
4. Select “Auto Detect” if your computer Setup sup-
ports this feature. If your computer does not Auto
Detect the drive, select the appropriate UDT (User
Definable Type) for the model being installed.
Then run Disk Manager.
6480MB
63
15
13,424
DHEA-36480
6480MB
63
16
12,592
DHEA-36480
4330MB
63
15
8,960
DHEA-34330
4330MB
63
16
8,400
DHEA-34330
Capacity
Sector
/Track
Heads
Cylinders
IBM model
number
Running Disk Manager
1. Boot to operating system from the hard drive or the
diskette.
2. Insert the Ontrack diskette.
3. Type DM and press [ENTER] to run Disk Manager.
4. Under “Select an Installation Option”, select (E)asy
Disk Installation.
5. Select a drive for installation; Disk Manager will
partition and format the drive.
6. A status dialog will indicate a successful instal-
lation.
If, after complete installation, your system will not boot
up, recheck all settings. If the system still fails to boot
up, remove the new drive from your system to return
to your original configuration and contact technical
support.
®
© International Business Machines Corporation 2002
www.ibm.com/harddrive
IBM Hard Disk Drive Technical Support Center
Telephone: 888.IBM.5214 or 507.286.5825
Fax: 507.253.3748
E-mail: [email protected]
Singapore Technical Support Center
Telephone: (65)6418.9595 or 1800.418.9595
E-mail: [email protected]
IBM Systems Storage Division
5600 Cottle Road
San Jose, CA 95193
www.ibm.com/storage
Printed in the United States of America
11-02
All Rights Reserved
IBM is the registered trademark of International Business
Machines Corporation.
Other company, product, and service names may be trademarks
or service marks of others.
Produced by the IBM Technology Group Support Center.
Hard Disk Drive Specifications for Deskstar 5 DHEA-34330 &
DHEA-36480, revision 2.0
Product Description data represents IBM’s design objectives
and is provided for comparative purposes; actual results may
vary based on a variety of factors. This product data does not
constitute a warranty. Questions regarding IBM’s warranty
terms or methodology used to derive this data should be
referred to the IBM Hard Disk Drive Technical Support
Center. Data subject to change without notice.
Date: 26 November 2002
