IBM DCS3860, Installation, User'S, And Maintenance Manual

Page: 53 / 204

Installing and removing the handles
After you install the storage enclosure in the rack cabinet and remove the handles,
store the handles for future use.
Installing the handles
1. Locate the box of handles.
2. To install a handle on the storage enclosure, place notch at the bottom of the
handle in the opening in the storage enclosure chassis, and push the handle in
and up until the latch at the top of the handle secures the handle to the chassis.
3.
Repeat step 2 for the remaining handles.
Removing the handles
Complete the following steps to remove the handles from the storage enclosure:
1. Release the latch with your thumb and pull down and away from the unit.
2. Repeat step 1 for the three remaining handles.
Thumb
latch
Handle
3. Store the handles for future use.
Installing the DCS3860 into the rack cabinet using a lift tool
Complete the following steps to install the storage enclosure if you have acquired a
lift tool:
1. Prepare the storage enclosure for installation:
a.
Position the lift tool so that it faces one side of the shipping box.
b. Remove the foam shipping material from the sides and ends of the storage
enclosure.
c.
If necessary, cut away sides of the shipping box so that the lift tool has
access to the storage enclosure.
Chapter 2. Installing the DCS3860
35