IBM BNT, Installation Manual

Page: 49 / 88

5. Reset and restart the switch module as described in “Resetting and restarting
the switch module.”
Resetting and restarting the switch module
To activate the new image or images, you must reset the switch module. To reset
the switch module, complete the following steps:
1. From the I/O Module Tasks menu, click Admin/Power/Restart . The
management module window opens.
2. Select the I/O-module bay on which the software update was just installed.
3.
Click
Power Off Module(s)
.
4. Select the I/O-module bay on which the software update was just installed.
5.
Click Power On Module(s) . Wait 60 seconds for POST to be completed.
6. Click Monitors , and select Firmware VPD . The Firmware VPD window opens.
7.
In the Firmware VPD window, locate the I/O Module Firmware VPD area.
Page down to the number of the I/O-module bay that contains the switch
module that you just installed; then, note the corresponding level of the
software for the switch module. Confirm that the software build ID and
revision reflect the correct software release.
Chapter 7. Updating the software
37