IBM 9009-22A, Manual

Page: 73 / 116

Figure 54. Loosening the NVMe drive backplane screws
8. Pull the NVMe drive backplane (B) away from the chassis that uses the thumbscrews, then lift the
NVMe drive backplane from the chassis. See Figure 54 on page 59.
9. If the removed part is used again, place the part on an electrostatic discharge (ESD) mat.
Replacing the NVMe drive backplane in the 9009-22G or 9223-22S system
To replace a NVMe drive backplane in the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. The chassis has four alignment pins (B) to secure the NVMe drive backplane (A). Insert the NVMe drive
backplane as shown in the following figure. Ensure that the alignment pins fit through the holes in the
NVMe drive backplane.
Drive backplanes for the 5105-22E, 9008-22L, 9009-22A, 9009-22G, 9223-22H, or 9223-22S 59