IBM 8852 - BladeCenter H Rack-mountable, Installation And User Manual

Page: 45 / 82

To install a power module, complete the following steps.
3rd power
module
4th power
module
Power-module
filler
Handle
(open)
Handle
(open)
1. Remove the module filler if one is installed.
2. Make sure that the handle on the power module is in the open position.
3. Orient the new power module to the selected power-module bay:
v
For the upper power-module bays, the rear connector on the power module
must be facing down.
v For the lower power-module bays, the rear connector on the power module
must be facing up.
4. Slide the module into the bay until it stops; then, push the handle to the closed
position.
Release buttons
Release buttons
5. Align the blue tabs on the ends of the bezel with the corresponding holes in the
front of the BladeCenter unit.
6. Firmly press the bezel into the BladeCenter unit until the tabs lock it into place.
Chapter 3. Installing the BladeCenter unit and options
29