IBM 8275, User Manual

Page: 70 / 110

v
Code (the default)
v
Configuration
For Upload
v
Configuration
v
Error log
v
System trace
v
Trap log (the default)
Upload or Download Mode
The mode is either XMODEM or TFTP. XMODEM is only valid when file
transfer is initiated via the serial EIA 232 port. The default value is
XMODEM.
Start Transfer Now:
You indicate Yes or No.
File Name:
The file name can be up to 16 alphanumeric characters. The 8275-416
remembers the last file name used. The default value is blank.
Note: File Name, File Path, and TFTP Server IP Address are applicable
only if the Transfer Mode is TFTP.
File Path:
The directory path where the file is located. The 8275-416 remembers the
last file path used. The default value is blank.
TFTP Server IP Address:
The IP address of the server where the file is located. It is valid only when
the Transfer Mode is TFTP. The address is 4 decimal bytes ranging from 0
to 255. The default value is zeroes.
Reset Utility
8275-416 allows you to reset the 8275-416 without powering off. Reset means that
all network connections are terminated and the boot code executes. The 8275-416
uses the stored configuration to initialize the 8275-416 . You are prompted for
confirmation if you want the reset to proceed. A successful reset is evidenced by
the LEDs on the 8275-416 .
After selecting Reset Menu from the System Utilities Menu, you are given the
choice of the resets you can request as shown Figure 44 on page 57.
56
8275-416 User’s Guide