IBM 8248-L4T, Manual, Page: 35 / 214

9. In the Specify either physical location or resource name field, type the physical location that you
had previously recorded in this procedure.
10. Select
2
(Install device) for the Action to be performed.
11. Set the time delay, for example, for one minute: 01 .
Note:
You can set an appropriate time delay of 01 - 19 minutes to allow adequate time to access the
disk drive or solid-state drive.
12. Do not press Enter yet, first complete installing the disk drive or solid-state drive.
Select from the following options:
v
If you are installing a drive in a system or in an expansion unit, go to “Installing a disk drive or
solid-state drive in the 8248-L4T, 8408-E8D, or 9109-RMD system or expansion unit.”
v If you are installing a drive in the 5887 disk drive enclosure, go to “Installing a disk drive or solid-state
drive in the 5887 disk drive enclosure” on page 21.
v
If you are installing a drive in the EDR1 PCIe storage enclosure, go to “Installing a solid-state drive in
the EDR1 PCIe storage enclosure” on page 21.
Installing a disk drive or solid-state drive in the 8248-L4T, 8408-E8D, or
9109-RMD system or expansion unit
Complete the following steps to install a disk drive or solid-state drive in a system or in an expansion
unit:
1. If the slot you want to use contains a disk drive filler, remove the disk drive filler from the slot. For
instructions, see “Removing a disk drive filler from the 8248-L4T, 8408-E8D, or 9109-RMD” on page
75.
Device Concurrent Maintenance
Type the choices, then press Enter.
Specify either physical location or resource name.
Physical location:
U787A.001.1234567-P3-D4
or
Device resource name:
Specify action as 1=Remove device 2=Install device
Action to be performed . . . . . . . .: 2
Enter a time value between 00 and 19.
Time delay needed in minutes . . . . .: 01
F3=Exit F5=Refresh F12=Cancel
Figure 10. Example Device Concurrent Maintenance display
Installing a disk drive or solid-state drive
19