IBM 8203-E4A, Manual

Page: 31 / 82

5. Install the front cover onto your system. See “Installing the front cover on the 8234-EMA, 9117-MMA,
or 9406-MMA” on page 41.
6.
Verify that the new resource is functional. See “Hardware service manager Verify option” on page 52.
7. Start the system. See “Starting the system or logical partition” on page 27.
Note: If a ball or dot is displayed in the middle of the control panel, toggle between function 02 and
function 01 until the ball or dot disappears.
Removing and installing the 8234-EMA, 9117-MMA, or 9406-MMA
control panel filler
You can install or remove the control panel filler from the server.
Attention: If you are not immediately installing or replacing the control panel, a control panel filler
must be in place when the system power is on for proper air flow and cooling.
Note: You might have a 2.5-inch or a 3.5-inch disk drive. The Procedures are the same for both. Any
differences are noted.
Removing the control panel filler
To remove the control panel filler, complete the following steps:
1.
Remove the front cover from your system. See “Removing the front cover from the 8234-EMA,
9117-MMA, or 9406-MMA” on page 40.
2. Locate the control panel filler.
3.
Remove the control panel filler by pressing the locking tabs located on either side of the filler,
grasping the edges of the panel, and pulling it out of its bay.
Installing the control panel filler
To install the control panel filler, complete the following steps:
1. Carefully slide the control panel filler into the control panel bay until you feel the locking tabs lock in
place.
2. Install the front cover onto your system. See “Installing the front cover on the 8234-EMA, 9117-MMA,
or 9406-MMA” on page 41.
Chapter 2. 8234-EMA, 9117-MMA, or 9406-MMA control panel
23