Blue or terra-cotta on a part of the hardware indicates a touch point where you can grip the hardware
to remove it from or install it in the system, open or close a latch, and so on. Terra-cotta might also
indicate that the part can be removed and replaced with the system or logical partition power on.
5.
Ensure that you have access to a medium, flat-blade screwdriver, a Phillips screwdriver, and a pair of
scissors.
6.
If parts are incorrect, missing, or visibly damaged, do the following:
v
If you are replacing a part, contact the provider of your parts or next level of support.
v
If you are installing a feature, contact one of the following service organizations:
– The provider of your parts or next level of support.
– In the United States, the IBM Rochester Manufacturing Automated Information Line (R–MAIL)
at 1–800–300–8751.
In countries and regions outside of the United States, use the following Web site to locate your service
and support telephone numbers:
7.
If you encounter difficulties during the installation, contact your service provider, your IBM reseller,
or your next level of support.
8.
If you are installing new hardware in a logical partition, you need to understand and plan for the
implications of partitioning your system. For information, see Logical Partitioning.
Starting the system or logical partition
Learn how to start a system or logical partition after performing a service action or system upgrade.
Starting a system that is not managed by a Hardware Management
Console
You can use the power button or the Advanced System Management Interface to start a system that is
not managed by a Hardware Management Console.
To start a system that is not managed by a Hardware Management Console (HMC), follow these steps:
1.
On a rack-mounted system unit, open the front rack door, if necessary. On a stand-alone system unit,
open the front door.
2.
Before you press the power button on the control panel, ensure that power is connected to the system
unit as follows:
v
All system power cables are connected to a power source.
v
The power-on light, as shown in the following figure, is slowly flashing.
v
The top of the display, as shown in the following figure, shows
01 V=F
.
Tip:
The system attention light, as shown in the following figure, does not appear on the control
panel on the model 9117-MMA.
3.
Press the power button
(A)
, as shown in the following figure, on the control panel.
Chapter 3. Common procedures for installable features
27
Summary of Contents for 8203-E4A
