IBM 7944, Installation And User Manual

Page: 91 / 150

Figure 57. Virtual media key installation
If you have other devices to install or remove, do so now. Otherwise, go to “Completing the installation” on
page 100 .
Installing the optional two-port Ethernet adapter
Use this information to install the optional two-port Ethernet adapter.
To install the Ethernet adapter, complete the following steps:
Step 1. Read the safety information that begins on “Safety” on page iii and “Installation guidelines” on page
41 .
Step 2. Turn off the server and peripheral devices and disconnect the power cords.
Step 3. Remove the cover (see
“Removing the cover” on page 48 ).
Step 4. Remove the PCI riser-card assembly (if installed) from PCI riser connector 1 (see “Replacing a PCI
riser-card assembly” on page 64 ).
Step 5. Attach the rubber stopper on the chassis, along the edge of the system board, as shown in the
following illustration.
Chapter 2
.
Installing optional devices
81