IBM 7199-92X, Installation And User Manual

Page: 66 / 82

– From the user interface, click Appliance
→
Settings
→
Ethernet Interfaces .
You must turn off the appliance before replacing the Ethernet module.
To replace an Ethernet module:
v
If the appliance is not turned off, turn off the appliance by pressing the power
button located on the front of the appliance. The fault LED on the front of the
appliance should not be illuminated.
v Unplug all power cords.
v
Grasp the blue latch and pull outward.
v
Pull the lever toward you to pull out the Ethernet modules, as shown in
Figure 18.
v
Set aside the Ethernet module.
Attention: Ensure that the gold connectors at the rear of the module do not
come into contact with your hands or with the packing material as you unpack
the replacement module. Avoid damaging the gold connectors against the
chassis as you insert the replacement module.
v Unpack the replacement module.
v
Carefully align the module, and insert into the appliance.
v
Push the Ethernet module forward until the module is in place.
v
Push the blue latch back in place
v
Plug in all power cords.