IBM 7163, Problem Determination And Service Manual

Page: 74 / 210

3. Connect the cables and power cords (see “Connecting the cables” on page 40
for cabling instructions).
4. Turn on all attached devices and the server.
Removing the Remote Supervisor Adapter II SlimLine
To remove the Remote Supervisor Adapter II SlimLine, complete the following
steps.
Remote Supervisor Adapter II
SlimLine guide
Remote Supervisor Adapter II
SlimLine
Retention latch
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 37.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables necessary to replace the device.
3. Remove the top cover (see “Removing the top cover” on page 41).
4. Open the retention latch on the Remote Supervisor Adapter II SlimLine guide.
5. Lift the Remote Supervisor Adapter II SlimLine and Interposer card assembly
out of the server.
6. If you are instructed to return the Remote Supervisor Adapter II SlimLine, follow
all packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Replacing the Remote Supervisor Adapter II SlimLine
To install the replacement Remote Supervisor Adapter II SlimLine, complete the
following steps:
1. Assemble the Remote Supervisor Adapter II SlimLine and Interposer card:
58
IBM System x3755 Type 8877 and 7163: Problem Determination and Service Guide