IBM 71455RU, Installation And User Manual

Page: 100 / 136

Stop-tab
Release latch
Release latch
Stop-tab
Handle
Handle
3. Slide the system-board tray forward until the tabs at the bottom of the handles
touch the chassis; then, close the handles and press firmly on the release
latches to snap them into the locked position.
4. Replace the bezel (see “Replacing the MAX5 bezel”).
Replacing the MAX5 bezel
To replace the MAX5 bezel, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 32.
2. Align the bezel alignment tabs with the chassis and press the bezel onto the
chassis until it snaps into place.
Bezel
Alignment
tab
Alignment
tab
Release
tab
Release
tab
Connecting the MAX5 cables
To cable the MAX5 to the host server, see the QPI cable option documentation and
the EXA cable option documentation. Be sure to turn off the host server before you
connect any cables to or disconnect any cables from the MAX5 memory expansion
module.
82
IBM System x3850 X5 and x3950 X5 Types 7145 and 7146: Installation and User’s Guide