IBM 7014-T42, User Manual

Page: 34 / 74

Replacing a 7014-T00 or 7014-T42 side panel:
Use the procedure in this section to replace a side panel on a rack.
To replace a side panel, complete the following steps:
1. Tilt the top of the side panel slightly toward you.
2. Place the bottom of the side panel onto the ridge on the bottom of the rack.
3. Slide the top of the side panel into place and close the locking latches.
Note: If your rack uses ruggedized kit, you must install a securing screw into each side panel that
was installed. See “Ruggedized kit” on page 30.
Removing and replacing 7014-T00 or 7014-T42 trim panels
Racks that are installed with multiple processor drawer systems can use front trim panels instead of
doors. For racks that use trim panels, a reduced-interference panel type must be installed when certain
expansion unit models are present. Use the procedures in this section to remove the existing trim panels
from the rack and replace them with the reduced-interference panel type.
Removing the 7014-T00 or 7014-T42 trim panels:
For racks that use trim panels instead of doors, a reduced-interference panel type must be installed when
certain expansion unit models are present. Use the procedure in this section to remove the trim panels.
To remove the existing rack trim panels, complete the following steps:
Figure 20. Replacing the side panel
22
Power Systems: Racks and rack features