IBM 6550-23N, Service Manual, Page: 7 / 44

1-3
Customizing Your Monitor
6
To
adjust the horizontal centering of the
picture
adjust the vertical centering of the
picture
adjust the horizontal size of the
picture
adjust the vertical size of the picture
enlarge or reduce the picture
Using the SIZE/CENTER On-
screen Display
The SIZE/CENTER settings allow you to adjust the
picture’s size, centering, or zoom.
Once the setting is adjusted, it will be stored in memory for
the current input signal.
1
Press the button.
The MENU OSD appears.
2
Press the . / > buttons to select “ SIZE/CENTER”
and press the button again.
The SIZE/CENTER OSD appears.
3
Press the
.
/
>
buttons to select the item you want to
adjust.
Select
(Horizontal Centering)
(Vertical Centering)
(Horizontal Sizing)
(Vertical Sizing)
(Zoom)
4
Press the
?
/
/
buttons to adjust the settings.
Select
(Horizontal Centering)
(Vertical Centering)
(Horizontal Sizing)
(Vertical Sizing)
(Zoom)
Press the button once to return to the MENU OSD, and
twice to return to normal viewing. If no buttons are pressed,
the OSD closes automatically after about 30 seconds.
To reset, press the ? (reset) button while the OSD is on.
The selected item is reset to the factory setting.
Notes
The (Zoom) adjustment stops when the horizontal or vertical
size reaches its maximum or minimum value. The horizontal
adjustment value is not displayed in the menu.
To
/ . . . to move the picture right
? . . . to move the picture left
/ . . . to move the picture up
? . . . to move the picture down
/ . . . to increase picture width
? . . . to decrease picture width
/ . . . to increase picture height
? . . . to decrease picture height
/ . . . to enlarge the picture
? . . . to reduce the picture
2 6
S I ZE / CENTER
7
Getting Started
F
EN
ES
C
Customizing Your Monitor
Using the GEOMETRY On-
screen Display
The GEOMETRY settings allow you to adjust the shape and
orientation of the picture.
Once the
(Rotation) is adjusted, it will be stored in
memory for all input signals received. All other adjustments
will be stored in memory for the current input signal.
1
Press the button.
The MENU OSD appears.
2
Press the . / > buttons to select “ GEOMETRY” and
press the button again.
The GEOMETRY OSD appears.
3
Press the . / > buttons to select the item you want
to adjust.
Select
(Rotation)
(Pincushion)
(Pin Balance)
(Keystone)
(Key Balance)
To
adjust the picture rotation
adjust the picture sides
adjust the picture side balance
adjust the picture width
adjust the picture shape balance
For
(Rotation)
(Pincushion)
(Pin Balance)
(Keystone)
(Key Balance)
Press
/ . . . to rotate the picture clockwise
? . . . to rotate the picture counterclockwise
/ . . . to expand the picture sides
?
. . . to contract the picture sides
/ . . . to move the picture sides to the right
? . . . to move the picture sides to the left
/ . . . to increase the picture width at the
top
? . . . to decrease the picture width at the
top
/ . . . to move the top of the picture to
the right
? . . . to move the top of the picture to
the left
4
Press the
?
/
/
buttons to adjust the settings.
Press the button once to return to the MENU OSD, and
twice to return to normal viewing. If no buttons are pressed,
the OSD closes automatically after about 30 seconds.
To reset, press the ? (reset) button while the OSD is on.
The selected item is reset to the factory setting.
2 6
GEOMETRY