IBM 6400i, Setup Manual

Page: 185 / 370

IEEE 1284
185
Timeout
This is the value used by the printer to time out from the current port and
check the other ports for data to print. When the printer has not received data
from the host after a certain period of time, it needs to Timeout in order to
service the other ports.
•
10 Sec (the default)
•
1 Sec – 60 Sec
Report Status
When this option is enabled, faults are reported even if the fault is not on the
current active port. If the option is disabled, a fault on the printer is reported
only if it occurs on the active port.
•
Disable (the default)
•
Enable
Framing Errors
These are possible errors that can occur when serial interface settings of the
printer do not match those of the host computer.
•
Enable (the default). If a framing error occurs, a fault message will display
on the control panel.
•
Disable. If a framing error occurs, a fault message will not display on the
control panel.
Serial Interface Menu