IBM 6400-i05, Setup Manual

Page: 286 / 370

286
Chapter 6
Fault Messages
NON–VOLATILE MEMORY
FAILED No Non–volatile memory
fault. Contact your IBM service
representative. NOTE: You
can still print, but you
cannot save configuration
changes as the NVRAM is
defective.
A97 GRAPHIC CHECK
ERROR
PRESS STOP THEN START
Yes Printer has received a
non–printable character. Press Stop then Start.
ENERGY SAVER MODE
ACTIVE N/A Status message: printer
is in low–energy idle
state, all fans and higher
voltages are off, only
+5Vdc logic circuits are
active. No action necessary.
NOTE: If the printer was in
NOT READY state when
the energy saver mode
was activated, it will remain
in the NOT READY state
until the START key is
pressed.
HAMMER COIL BAD
#, #, #
No Malfunction of one or
more hammer coils. (You can continue to print
with degraded print
quality.) Contact your IBM
service representative.
NOT READY N/A Printer state message:
printer is offline, not in
communication with
host. No action necessary.
OPERATOR MENU
<first menu item>
N/A Non–error status
message. No action necessary.
OPERATOR MENU
LOCKED N/A Non–error status
message. No action necessary.
OPERATOR MENU
UNLOCKED N/A Non–error status
message. No action necessary.
PA1 SELECTED N/A Attach status message. No action necessary.
PA2 SELECTED N/A Attach status message. No action necessary.
P05 DIAGNOSTIC TEST
PASSED N/A Non–error status
message. No action necessary.
Table 12: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution