2006 Model L10 Storage Switch
2
Installation Instructions
Follow these instructions to install a Model L10 switch into a rack.
1. Unpack the Model L10 switch’s fixed rack-mount kit and verify that all ordered parts
are present. See Table 1 for a list of parts and the quantities supplied.
If any components are missing, contact a customer service representative
immediately. (Parts
and
are shown in Figures 2 and 3, respectively.)
Note: The rack-mount tray must be mounted using the 5/8-inch gap intervals. The
tray assembly will not mount properly using the 1/2-inch interval. At least 1U of
vertical space is necessary to accommodate the rack-mount tray assembly.
Table 1. Parts supplied with the Model L10 fixed rack-mount kit
Part
Description
Quantity
Rack-mount tray assembly
1
Rear mounting rail
2
Caged nut, for racks with square holes
12
Clip nut, for racks with round holes
12
Screw, hex, M6 x 16
12
Stop brackets
2
Cover panel
1
1
2
3
4
5
6
7
6
7
Figure 1. Rack assembly
l100038
