IBM 2292, User Manual, Page: 31 / 86

See the following illustration for the location of parts on the system board.
1
Microprocessor
9
Battery
2
DIMM connectors (1, 2, 3 left to right)
10
SCSI LED connector
3
Front panel connector
11
PCI slots
4
Power connector
12
Front panel audio connector
5
Diskette drive connector
13
CD-ROM audio connector
6
Primary IDE connector
14
AGP slot
7
Secondary IDE connector
15
12V Power connector
8
Clear CMOS/Recovery jumper
Installing memory
Your computer has three connectors for installing dual in-line memory modules
(DIMMs) that provide up to a maximum of 1 GB of system memory.
Note: Your computer will only support DIMM 1 and DIMM 2 (from left to right).
DIMM 3 will not be used due to mechanical restrictions.
Installing DIMMs
When installing DIMMs, the following rules apply:
v
Fill each system memory connector sequentially, starting at DIMM 1
v
Use 3.3 V, synchronous, 168-pin, unbuffered, 133 MHz, nonparity, synchronous
dynamic random access memory (SDRAM)
v
Use 64 MB, 128 MB, 256 MB, or 512 MB DIMMs in any combination
v
DIMM heights of 38.1 mm (1.5 inches)
To install a DIMM:
1. Remove the cover. See “Removing the cover” on page 17.
Chapter 3. Installing internal options — small desktop model
19