IBM 2073-700, Quick Installation Manual

Page: 7 / 82

Tables
1. How to connect SAS cables to expansion units. 25
2. Ethernet connections available with the control
enclosure .
. . . . . . . . . . . . 30
3. Ethernet connections available with the file
modules
. . . . . . . . . . . . . 31
4. How to connect Fibre Channel cables from file
modules to the controller. Refer to the graphic
below. .
. . . . . . . . . . . . . 33
5. LED status front of control enclosure. Refers to
item [1] in the figures above. .
. . . . . . 36
6. LED status rear of control enclosure. . . . . 37
7. LED status when control enclosure is powered
on.
. . . . . . . . . . . . . . . 38
8. This table (optional) is useful for identifying
the IP addresses and information necessary to
set up the initialization tool. The table entries
serve as a guide only. Fill in the Value column
with your system information. .
. . . . . 41
9. Create two files and enter one line each,
adjusted to the values fitting to your
environment. .
. . . . . . . . . . . 44
10. This table (optional) is useful for completing
the Easy Setup wizard. The table entries serve
as a guide only. Enter the Value column with
your system information. .
. . . . . . . 46
11. Remote support information . . . . . . . 48
12. CIDR subnet mask information . . . . . . 49
13. Authentication method information . . . . 50
14.
Active Directory Configuration Information
50
15. LDAP CONFIGURATION INFORMATION 52
16. NIS configuration information . . . . . . 53
© Copyright IBM Corp. 2011
vii