IBM 2073-700, Quick Installation Manual

Page: 51 / 82

Chapter 3. Configuring the system
This document helps you set up your system for the first time.
Setting up your system for the first time:
The following will guide you through setting up your system for the first time.
The process includes the following key steps:
v
Initialize the Storwize V7000
v
Initialize the file modules
v
Configure the software
v
Check the Storwize V7000 Unified system status
v
Upgrade the Storwize V7000 Unified software
v
Problems with initial configuration
v
Enable IBM Tivoli Assist On-Site (AOS)
Initialize the Storwize V7000
This document guides you through setting up the control enclosure.
The following Information is required before configuring your system. Fill in all
the information needed in the
Value column before proceeding with this
installation.
Note: You cannot use VLAN-based subnets to configure the system network. To
configure the Storwize V7000 Unified file module management IP address, file
module 1 and 2 IP addresses, subnet mask, and gateway address, you must
provide non-VLAN based network information. After the system is configured, use
the
chnwmgt command to change the Storwize V7000 Unified network settings to
switch to a VLAN-based subnet. This recreates the network with a VLAN-based
subnet.
Table 8. This table (optional) is useful for identifying the IP addresses and information
necessary to set up the initialization tool. The table entries serve as a guide only. Fill in the
Value column with your system information.
Field Value Notes
Storwize V7000 Unified
name Name associated with the
Storwize V7000 Unified IP
address (such as Storwize
V7000 Unified)
Storwize V7000 Unified IP
address IP address for the Storwize
V7000 Unified system (such
as 9.21.22.xxx)
Storwize V7000 Unified
subnet mask Subnet for the above
Storwize V7000 Unified
address (such as
255.255.255.0)
Storwize V7000 Unified
gateway address Gateway for Storwize V7000
Unified address to user
network (such as 9.21.22.1)
© Copyright IBM Corp. 2011
41