IBM 2073-700, Quick Installation Manual

Page: 14 / 82

__
v
License Function authorization document
__
v
Small form-factor pluggable (SFP) transceivers that are preinstalled in the
enclosure
__
v
Two USB keys, one for each file module.
Important: Use one of the file module USB keys to set up your system, not
the USB key that is supplied with the control enclosure.
Step 2. Identifying the hardware components
The following graphics and descriptions identify the various hardware components
and port locations for the control enclosure, expansion enclosure, and file modules.
Important: Use the USB key that is shipped with the file modules for
configuration. Set aside the USB keys that were shipped with the control
enclosures.
Control enclosure
Each enclosure has drives that are located on the front. Figure 1 and Figure 2 show
the front of an enclosure that has space for up to 12 or 24 drives
2
, depending
on the model, and a left end cap
1
and a right end cap
3
.
Control enclosure components
Figure 3 on page 5 shows the rear view of a control enclosure and identifies the
location of the power supply units and the canisters.
svc00694
1 2 3
Figure 1. This figure shows 12 drives and two end caps (model 2076-112).
svc00693
1 2 2 3
Figure 2. This figure shows 24 drives and two end caps (model 2076-124).
4
Storwize V7000 Unified: Quick Installation Guide