IBM 110 GB SDLT, User Manual

Page: 16 / 48

Step 5. Attaching cables
To attach the SCSI and power cables to the tape drive:
1. Locate the SCSI cable on your computer (a 68-pin (wide) ribbon cable with
one end connected to the SCSI adapter) and find the next available
connector that is farthest from the adapter. Use all empty bus connectors
beginning with the one farthest from the adapter to ensure better signal
quality.
Note: The SCSI adapter might be part of the computer system board or might be an
adapter installed in an expansion slot.
2. Attach the SCSI cable from your computer to the tape drive 68-pin SCSI
connector. The SCSI cable connector at the end of the SCSI cable will attach
to the drive only one way. Do not force the cable onto the drive.
Attention: Do not force the power cable into the tape drive power connector. If the
power cable is upside down and you force the connection, you might damage the
drive.
3. Connect the power cable connector to the four-pin connector on the tape
drive. If all the power cables are in use, purchase a dc Y-splitter cable,
which is available at most electronics stores. Split a cable to make a
connection available for the tape drive.
Step 6. Completing the installation
Check your work before closing the computer.
1. Be sure that the power and SCSI connectors are securely attached. Be sure
that the cables are neatly routed.
2. Replace the computer cover and secure it in place. Reconnect the power
cords and cables.
Step 7. Turning on the device
Turn on all attached devices; then turn on your computer. The tape drive
performs a power-on self-test (POST) within 15 seconds and then performs a
drive reset.
Step 8. Updating the configuration
For most computers, the configuration-setup utility program automatically
recognizes the new tape drive. However, you might have to provide
information about your system changes after you restart your computer.
1-8
110/220 GB SDLT Internal Tape Drive: User’s Guide