IBM 106, Hardware Installation And Maintenance Manual

Page: 81 / 120

The original packaging consists of an anti-static bag for each drive, an inner carton with protective,
padded slots for each drives, and an outer carton to hold three inner cartons of drives.
3. Disconnect only the cables necessary for the equipment move and remove the enclosure from the
rack.
4. Return all components, but not the drives, to the enclosure for shipping.
Do not return the drives to the enclosure until the enclosure is at its new location and is not to be
moved again.
Customer-replaceable units
CRUs addressing Model 106-drive chassis
Table 9. Model 106 product components for Model 106-drive chassis
Item
Enclosure component description Access
1 Disk drive (LFF/SFF) module: DDIC (Disk in drive carrier)
1. DDIC 3.5" LFF (disks of differing type/speed and storage
capacity: SAS/SATA/SSD)
2. DDIC 2.5" SFF with adapter (disks of differing type/speed
and storage capacity: SAS/SATA/SSD)
Top
2 Power supply unit (PSU) module available as AC unit (chassis
uses two PSUs of same model type)
Rear
3 Expansion module (EBOD canister) for storage expansion Rear
4 System fan module Rear
5 Controller fan module Top
6 HS Expander module (PCBA card) Top
7
Optical SAS Cable 4.3m (FRU and Production PN)
Optical SAS Cable 4.5m (FRU and Production PN)
MiniSAS HD to MiniSAS HD, L = 4.0m (COPPER) - Production
MiniSAS HD to MiniSAS HD, L = 4.0m (COPPER) - FRU
MiniSAS HD to MiniSAS HD, L = 5.0m (COPPER) - Production
MiniSAS HD to MiniSAS HD, L = 5.0m (COPPER) - FRU
N/A
8 AC power cord compatible with AC PSU N/A
Table 10. Part numbers of Customer-replaceable units
Part #
Part Desc Substitute Part
001LU642 10TB 3.5 HDD
001LU841 14TB 3.5 HDD
078P5611 4.3M Cable (Optical SAS)
078P5605 4.5M Cable (Optical SAS)
001LU640 4TB 3.5 HDD
Chapter 6. Troubleshooting and problem solving 63