© Copyright LOTRONIC 2012
Page 3
damage the machine.
•
To fill the tank, put the machine on a level place, open the liquid tank and pour high quality haze liquid into the
tank. Close the tank immediately after filling it.
•
It’s forbidden to spray directly towards persons. Keep far away from flammability and explosive objects
•
The haze is very hot, please keep a distance of at least 5 meters when using it
•
Please don’t touch the surface of the haze machine during the use because the housing will reach 40-80°C
•
When the machine doesn’t work, please check if the fuse is burnt out or not. If it is, replace it by an identical fuse,
find out the fault and restart the machine. But please note: the repair must be handled by professional.
INSTRUCTIONS OF USE
The unit can be controlled via the remote control, digital display control or DMX control.
First of all, please connect power cable and press power switch, the haze machine starts heating up and the LED
display will show
on the back side.
5.1 Remote control instruction:
After heating up is finished, the LED display will show
, it means that the unit is ready to operate. You can
use the remote control and the LED display will show F100.
If you want to change the control mode, you can press the ENTER key for 2 seconds until the LED display shows
.
5.2 DMX control and Digital display control setting:
Press “FUNC” key, enter MENU; Press
“
FUNC
”
key to choose the MENU that you want, and then press
“
ENTER
”
to confirm;
Or you press “DOWN” or “UP” key to choose MENU, and then press “ENTER" to enter the MENU; Press again
“ENTER” to keep the setting. You can press the “FUNC” key any time to exit the sub-MENU and return to the
previous directory.
Press ”FUNC” key
Addr
ENTER
A001
to
A512
ENTER
Set DMX address
confirm confirm DMX address
DMX address setting:
This machine has 1 DMX channel to control the haze output volume. The address range of machine is 0-255
(OFFH).
After setting DMX address, please use DMX controller to control machine.
Attention: on some old controllers it might be necessary to invert pin 2 and 3 and then they will work normally.
Setting of output volume
Press ”FUNC” key
out
ENTER
F001
to
F100
ENTER
Set haze output
confirm
confirm output volume setting
Press ”FUNC” key
SLNd
ENTER
/
NASt
ENTER
Set work mode
confirm confirm MASTER status
/
SLAu
ENTER
Confirm SLAVE status
