MANUAL - THINPAR-LED-RING
3
www.ibiza-light.com
•
Never disconnect the power cord by pulling or tugging on the cord.
•
Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an epileptic shock
(especially meant for epileptics)!.
•
The product is for decorative purposes only and not suitable as a household room illumination.
•
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manu
-
facturer or his service agent or a similar qualified person in order to avoid a hazard.
•
The light source of this luminaire is not replaceable. When it reaches the end of its life time, the whole unit
must be discarded..
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
FUSE REPLACEMENT
Locate and remove the unit’s power cord. Once the cord has been removed located the fuse holder located in
-
side the power socket. Insert a flat-head screw driver into the power socket and gently pry out the fuse holder.
Remove the bad fuse and replace with a new one.
Warning
: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact customer support
for further instructions. Continuing to use the unit may cause serious damage.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the
unit is secure and is able to support a weight of 10 times of the unit’s weight.
Never stand directly below the device when mounting, removing or servicing the fixture.
BUTTONS & CONNECTORS
No. Designation
No. Designation
1
Mounting Bracket
6
DMX Input (3-pole)
2
LEDs
7
DMX Output (3-pole)
3
Adjustment Screw
8
Power Input
4
Display
9
Power Output
5
Operating Buttons
LED DISPLAY
The LED display has 4 buttons: MENU / UP / DOWN / ENTER
MENU STRUCTURE
No. Display
1
d001
Address code (001-512)
2
Chnd
6 / 10 channel selection
3
Auxx
Au01-Au08 : colour selection
Au09: Jump
Au10: Gradient
Sou1: Sound controlled mode 1
Sou2: Sound controlled mode 2
4
St00
St00 no flash
St01-St16 strobe effect from slow to fast
5
SP00
SP01-SP16 Auto speed from slow to fast
6
R220
Red color selection (000-255)
Press "Confirm" key to
switch
G220
Green color selection (000-255)
UP
DOWN
MENU
ENTER
8.8.8.8.