Copyright Velocomp LLP 2008-2010
18
USING THE iAERO WITH AN ANT+SPORT
WIRELESS DFPM POWER SENSORS
HOW TO CONNECT THE IAERO WITH YOUR WIRELESS ANT+SPORT SENSORS
1)
Install your wireless DFPM on your bike according to directions provided by the
manufacturer.
2)
Install your iAero wireless mount and sensors on your bike.
3)
Attach your iAero to your wireless mount.
4)
Spin the crank to wake up the speed sensor, cadence sensor, and DFPM.
5)
Attach the HR strap to your chest. This wakes-up the HR strap.
6)
Spin the crank of your DFPM backwards several revolutions. This activates your
DFPM.
7)
Enter Setup and use the down arrow to find the “Scan No” screen.
8)
Click the center button; “No” will flash. Click the up arrow so that “Yes” flashes.
9)
Finally, press the center button of your iAero. Your iBike will scan for your wireless
sensors and, after a few moments, you’ll see “SPD FOUND”, “CAD FOUND”, “Pin
FOUND” (power in found). If you’re using an HR strap you’ll also see “HRT FOUND”.
Your iAero is now receiving speed and HR signals from your iAero sensors, and cadende
and power data from your DFPM.
HOW TO ZERO-OFFSET CALIBRATE YOUR WIRELESS DFPM
1)
Pair your wireless DFPM according to the steps above.
2)
Go to Setup/PCAL (power calibrate).
3)
Use the up arrow to find PCAL/START
4)
Press the center button. After a few seconds you’ll see the message PCAL/Done.
Your wireless DFPM is now calibrated.
NOTE
: FOR DETAILED INSTRUCTIONS REGARDING THE USE OF YOUR WIRELESS DFPM,
CONSULT THE DFPM OWNER’S MANUAL THAT WAS INCLUDED WITH YOUR DFPM
NOTE
: WHEN USING A WIRELESS DFPM WITH THE IAERO, THE POWER INFORMATION
DISPLAYED ON THE IAERO SCREEN IS MEASURED BY THE DFPM.
