ibidi Heating System 4 Slides – Silver Line
The Incubation Chamber 4 Slides fits on an inverted microscope stage equipped with a mounting
frame for multiwell plates. For parallelization of experiments, the Heated Plate for 4 µ-Slides pro-
vides a platform to observe 4 slides in parallel.
Optionally, the Objective Heater Universal – Silver Line can be connected to the Temperature Con-
troller to keep the objective warm, thereby avoiding cooling of the sample by heat transfer from the
sample to the objective while imaging. Detailed information on the Objective Heater Universal is
given in the
Objective Heater Universal – Silver Line instructions
4.3
ibidi Temperature Controller – Silver Line
The ibidi Temperature Controller – Silver Line is designed to precisely operate the different ibidi
Silver Line heating devices, including the Incubation Chamber 4 Slides – Silver Line. In total, 6
channels are available, each channel accommodating one heated component (e.g., the Heated Lid
and Heated Plate of the Incubation Chamber 4 Slides). In addition, an external Temperature Sensor
can be connected.
The front panel enables access to the Temperature Controller’s settings. The front panel display
shows the values of set (‘S’ = set) and actually measured (‘I’ = is) temperatures. The temperature set
values and other settings can be adjusted via the control buttons (Section
). If you wish to control
the Temperature Controller via PC, use the IncuControl software (Section
1
3
4
6
2
5
ibidi Temperature Controller
Plate
I 38.0
S[ 38.0]
Run
Lid
42.1
42.0
Setup
N.C.
1
Figure 5: Front view of the ibidi Temperature Controller – Silver Line.
The LEDs of the front panel indicate the status of the channels, connection to power supply, and USB
connection (Figure
Control LEDs Channel 1–6
LED off
Channel inactive
LED on
Channel active
LED fast blinking
Channel error
Please contact ibidi at
Version 1.0 (August 1, 2022)
18
Instruction Manual
