15
Set the mode adjustment knob to the ‘rotary drilling’ position for
screw-driving* and for drilling into steel, wood and plastics.
Depending on your tool, either you can operate with the SDS Plus
tool holder or using the additional drill chuck provided.
(Refer ‘Fitting Drill chuck and adapter’ section for installation)
Proceed the same steps as described for hammer-drilling.
Set the mode adjustment knob to the ‘hammering only’ position.
Insert the appropriate chisel and rotate it by hand to lock it into
position.
Adjust the auxiliary handle as required.
Switch on the tool and start working. Always switch off the tool
when work is finished and before unplugging.
(Refer ‘Indexing the chisel position’ section for preparation)
ROTARY DRILLING
CHIPPING AND CHISELLING
WARNING!
Applying force more than necessary will not only
accelerate the work at all, but will worsen the tip edge of the drill
bit and reduce the service life of the rotary hammer in addition.
Drill bit may snap off while withdrawing the hammer from the
drilled hole. For withdrawing, it is important to use a push-motion.
Do not attempt to drill anchor holes or holes in concrete with the
machine set in the rotation only function.
Do not attempt to use the rotary hammer in the rotation and
striking function with the drill chuck and chuck adaptor attached.
This would seriously shorten the service life of every component
of the machine.
IBL RH26-26/24
