10
SI-623-N User Manual
2.1 Installations
Before installing any card or module into the device, remove the screws shown
in the picture below. Pull out the side covers and then remove the bottom
cover.
2.1.1
Memory Module Installation
To install or replace modules, locate the memory slot on the board and perform
the following steps:
1. Align the key of the memory module with that on the memory slot and
insert the module slantwise.
2. Gently push the module in an upright position until the clips of the slot close
to hold the module in place when the module touches the bottom of the
slot.
To remove a module, use your fingers to press the clips outwards until the
module pops up. Grab the module gently and pull it out of the slot.