![background image](http://html1.mh-extra.com/html/ibase-technology/ibr210/ibr210_user-manual_3251079019.webp)
Hardware Configuration
IBR210 User’s Manual
11
2
2.2
Setting the Jumpers
Set up and configure your IBR210 by using jumpers for various settings and
features according to your needs and applications. Contact your supplier if
you have doubts about the best configuration for your use.
2.2.1
How to Set Jumpers
Jumpers are short-length conductors consisting of several metal pins with a
non-conductive base mounted on the circuit board. Jumper caps are used to
have the functions and features enabled or disabled. If a jumper has 3 pins,
you can connect either PIN1 to PIN2 or PIN2 to PIN3 by shorting.
A 3-pin jumper
A jumper cap
Refer to the illustration below to set jumpers.
Pin closed Oblique view Illustration in the manual
Open
1-2
2-3
When two pins of a jumper are encased in a jumper cap, this jumper is
closed
, i.e. turned
On
.
When a jumper cap is removed from two jumper pins, this jumper is
open
,
i.e. turned
Off
.
Pin#
1
2
3
1 2 3
1 2 3
1 2 3
Summary of Contents for IBR210
