24
IBR117
User’s Manual
3.1
Make a Recovery SD Card
Note:
This is for advanced users who has IBASE standard image file only.
Basically, IBR117 is preloaded with O.S (Android / Linux) into eMMC by
default. Connect the TFT-LCD with IBR117 (or HDMI), and 12V power
directly.
This chapter guides you to make a recovery boot-up SD card. IBASE
optionally provides 7” /15” / 21.5” LVDS panel and HDMI display for you to
prepare the software application pre-development easily under Linux
platform.
3.1.1
Preparing the Recovery SD Card to Install Linux /
Android Image into eMMC
Note:
All data in the eMMC will be erased.
1.
System requirements:
Operating System: Windows 7 or later
Tool: mfgtools-2.3
SD card: 4GB or greater in size
2.
Insert your SD card to this board (i.e. the P3 connector), connect the
board to PC through the mini-USB port (i.e. the P6 connector), and
change the boot mode to burning state.
Summary of Contents for IBR117
