Chapter 4
Troubleshooting
This Chapter provides solutions to problems for the installation and operation of the 3G+
Wireless-N Router. You can refer to the following if you are having problems.
1 Why can’t I configure the router even the cable is
plugged and the LED shows on?
Do a
Ping test
to make sure that the WiFi Combo
Note:
It is recommended that you use
Router is responding.
an Ethernet connection to configure it.
Go to
Start > Run
.
1. Type
cmd
.
2. Press
OK.
3. Type
ipconfig
to get the IP of default gateway.
4. Type
“
ping 192.168.1.1”.
Assure that you ping the correct IP Address assigned to
the 3G+ Wireless-N Router. It will show four replies if you ping correctly.
If not then Ensure that your Ethernet Adapter is working, and that all network drivers are
installed properly. Network adapter names will vary depending on your specific adapter. The
installation steps listed below are applicable for all network adapters.
1. Go
to
Start > Right click on “My Computer” > Properties
.
2.
Select
the
Hardware Tab
.
3. Click
Device Manager
.
55
Summary of Contents for iB-W3GX150N
