Modello - Modèle - Model
Modell - Modelo
GLEE MID 23
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
16/68
N° DOC
UM000427
AVOID USING NAKED FLAMES OR SPARKS INSIDE
THE APPLIANCE.
IN THE EVENT OF DAMAGE:
•
Keep the appliance far from flames or ignition sources.
•
Ventilate the room well for a few minutes.
•
Switch off the equipment, remove the power supply plug
•
Inform customer service.
•
The higher the refrigerant content in the equipment, the larger the
room must be hosting the equipment.
•
In rooms that are too small, a mix of flammable air and gas can form
in the event of a leak.
•
Always keep the instructions manual safe and if the
appliance is sold, hand it over to the new owner.
• The unit must neither be exposed or used outside of the
point of sale. It must be sheltered from weather conditions.
The upper part of the appliance must remain free.
• Do not ever touch or handle the appliance with bare feet
or with wet hands and feet.
•
After installing the appliance make sure that it is not
positioned on the power cable.
•
To disconnect the appliance from the mains, take out the
plug. Do not pull the power cable out of it.
• Do not store explosives, such as pressurized containers
with flammable propellant, in this appliance.
• Cabinet must be installed on a perfectly even surface.
• Do not apply power to the appliance if it is damaged. In
case of doubt, contact the support service or the distributor.
• If the power cable is damaged, do not use the appliance
or attempt a repair: This must be changed by the
manufacturer or the support service.
• Changing of electrical components must exclusively be
carried out by qualified personnel.
